samsung front load dryer heating element

If the thermal cut-off fuse is bad, it’s because the high-limit thermostat is bad (not cutting out at high temps). They have a cycling thermostat and a thermo-cutout kit consisting of a high-limit thermostat and a thermal cut-off fuse. Whirlpool Gas dyers and all gas dryers made by Whirlpool all have the same design. You literally have to somehow raise the temp to it’s cut-out temp and then check continuity. If you check then for continuity at room temperature, you will not know if they are bad. You have to check the thermostats for continuity at their cutout temperature which can be up to 265 degrees in the case of the high limit thermostat. In my experience, (gas dryer) there are two reasons the thermal fuse will blow.ġ) Blocked vent causing the dryer to overheat.Ģ) Thermostats failing to cut out at correct temperature – and again causing the dryer to overheat. Categories Dryer, How To, Repair Guides, Troubleshooting & Maintenance Tags dryer thermal fuse, failed relay stuck, samsung dryer not heating, thermal fuse keeps blowing What brand machine do you have and what was causing the problem? Comment now and let us know. Have you had issues with a thermal fuse tripping?

The simple fact is, it doesn’t happen for no reason at all. In the end, anytime the thermal fuse or cutoff trips, it will need to be replaced.Īs a one-time use part, it’s not designed to be reset.Īlso, remember to track down the actual problem when this fuse blows. Plug the dryer in and test to see if it’s working properly.Position the new heating element to the heater box properly and screw into place.Remove the high-heat thermostat from the old heating element and transfer it to the new one.Mark the location of each wire, so you can remember where they go later.The heating element will be located near the bottom of the machine, you’ll need to disconnect the wires going to it.To repair this problem you will need to follow these steps: When this occurs it will cause your dryer’s heating element to remain “ON” constantly, even during the fluff or AIR ONLY cycle.Ĭycling thermostat just not able to control amount of heat produced by the heating element.Įventually, this will cause your dryer to overheat which will trip the thermal cutoff fuse. When the coils in the heating element expanding, they can touch metal casing and it can cause the heating element to become grounded.

Samsung front load dryer heating element